KOBA Evaluation Software for CMM Calibration
KOBA ITI evaluation software for DKD calibration, with approval of the PTB, is available in a full or a "lite" version. The full version:
- manages any number of CMMs
- manages up to 999 inspections per CMM, with up to 7 individual measurement per inspection
- can read almost any ASCII measuring file
- permits altnerative evaluation according to VDI/VDE 2617 or ISO 10360
- validates the probe system with a ring gage standard (3x12 points)
- validates the probe system with a sphere standard (3x17 or 1 x 25 points
- Scanning test with a sphere
| Evaluation of Gage Block Measurements: | Deviation from length Coupling of up to six staggered measurements Evaluation under consideration of the calibration uncertainty of the gage block Calculation of global correction parameters for CMM scales and angles between CMM axes. |
| Evaluation of Step Gage Measurements: | Deviation from length and deviation from position Coupling of up to six staggered measurements Evaluation under consideration of the calibration uncertainty of the step gage Calculation of global correction parameters of CMM scales and angles between CMM axes |
| Evaluation of Sphere Plate Measurements: | Deviation from length and deviation from position Evaluation under consideration of the calibration uncertainty of the sphere plate Calculation of global correction parameters for CMM scales and angles between CMM axes Evaluation of measurement capability from sphere plate measurements |
| Evaluation of Cone and/or Ball Bar Measurements: | Deviation from length and deviations from position Coupling of up to six staggered measurements Evaluation considering the calibration uncertainty of the ball bar Calculation of global correction parameters for CMM scales and angles between CMM axes Evaluation of measurement capability from ball bar measurements |
- Gage Blocks
- Step Gages
- Sphere Plates
- Ball Bar or Cone
Applicable SIC Codes: 3423, 3545, 5049, 5084 Applicable NAICS Codes: 332212, 333515, 423490, 423830